Water-thinned rubber-latex paint is already an old reliable, though it is only about 10 years old. It accounts for a big percentage of all paint sold and is still the most widely available of the easy-to-use finishes. One new type is a combination vinyl-rubber paint that is said to do a better job on interiors than either vinyl or rubber alone because it dries faster, lasts longer and has less sheen.
Anti-condensation paints are used for rooms with humid conditions such as kitchen and bathrooms. This paint is usually formulated to prevent condensation and often includes fungicide.
Feel free to email me if you have questions at the email addresses below. But most important, you'll find that with each painting you'll get better and better. Carry forward everything you learn from each work and eventually you'll have real talent! But only if you keep at it. And don't worry about people telling you you're crazy. They told that to van Gogh too! Sweet justice Vincent, sweet justice. He's certainly getting the last laugh, isn't he? And the world will know who Vincent van Gogh was for the rest of time. Not a bad gig.
Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint.
For localities where such conditions exist, self-cleaning paints should be selected. These paints are usually so designated on the label. Concrete, plaster, and metal surfaces each present special problems in painting. For instance, paint for use on masonry or new plaster must be resistant to dampness and alkalies, and paints used on steel must have rust-inhibitive properties.
Use Plain White Primer for Light Paint Colors. In our first case, if you decide to paint a wall in your house with a light yellow color, but the wall is currently a deep dark brown, you will go through bucket after bucket of paint trying to cover that brown, easily doing 4 - 6 coats or more. But if you put down a coat of white primer first, you could be done after 2 coats of paint.
Treat yourself to a good lunch and forget the diet. It is amazing what some pizza or a good burger will do for the afternoon painting push.